Cessco Fire Ant Killer

Provides Quick Killing Action and Residual Control

ACTIVE INGREDIENTS:
*Tetramethrin……………………………0.20%
**Permethrin……………………….……0.50%
***Piperonyl Butoxide Technical…….....1.00%
OTHER INGREDIENTS:…….....…....…98.30%
                                                                  100.00%

*1-cyclohexene-1,2-dicarboximidomethyl 2,2 –dimethyl- 3-(2-methyl-propenyl) cyclopropanecarboxylate.
**(3 – phenoxypheny) methyl (+/-) cis/trans3- (2,2- dichloroethenyl) 2,2 dimethylcyclopropanecarboxtlate.
    Cis/trans ratio:min. 35% (+/-) cis and max. 65% (+/- )trans.
***Equivalent to min. 0.8% (butylcarbityl) (6- propylpiperonyl) ether and 0.2% related compounds.

Net Weight: 16 Oz. (454 grams)

Directions for use

It is a violation of federal law to use this product in a manner inconsistent with its labeling.

• Cessco fire ant killer is for outdoor use only. Product can only be applied with a soil injection probe.
• Wear goggles or safety glasses and chemical resistant gloves when attaching probe and during application of this product.
• Shake well before using.

For Treatment of Fire Ants
Seen from above fire ant mounds appear roughly circular. Visually divide mound into four quadrants and determine mounds’ center. Probe insertions and treatment should be made in center of each quadrant with final insertion being in center of mound.

Attach soil injector probe firmly onto can. Holding probe approximately 1 inch above mound, begin spraying and slowly insert probe into mound. Continue spraying for entire
mound treatment. To maximize spray distribution, push probe into mound until resistance to further insertion is felt (contact with firm dirt), indicating that probe has reached bottom of mound.

Only one injection site is necessary on a mound 6 inches or less. The injection in a 6 inch or smaller mound should be for 5 seconds. Larger mounds should be treated in several injections on the basis of size—10 seconds total for mounds 6-12 inches in diameter, 15 seconds total for mounds 12-18 inches diameter, and 20 seconds minimum for mounds greater than 18 inches diameter. On large mounds, treatment may be extended by 1 to 2 additional seconds, in order to insure that aerosol formulation reaches all cavities within the mound or colony. Reexamine the mound after 7 days and re-treat if any activity is apparent. Look for new mounds in the immediate vicinity and treat these as well in order to prevent inefficiency from mound migration. For best results, apply in cool weather or in early morning or late evening hours.

NOTICE: Buyer assumes all responsibility for safety and use no in accordance with directions.

Precautionary Statements

Hazards to Human & Domestic Animals
Caution
Avoid contact with skin or clothing. Wash thoroughly with soap and water after handling.

First Aid
If Swallowed: Call a Poison Control Center or doctor immediately for treatment advice. Have person sip a glass of water if able to swallow. Do not induce vomiting unless told to do so by a Poison Control Center or doctor.
If Inhaled: Move victim to fresh air. If person is not breathing, call 911 or ambulance, then give artificial respiration, preferably mouth-to-mouth if possible. Call a Poison Control Center or doctor for further treatment advice.
If In Eyes: Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if
present, after the first 5 minutes, then continue rinsing eyes. Call a Poison Control Center or doctor for further
treatment advice.
If On Skin or Clothing: Take off contaminated clothing. Rinse skin immediately with plenty of water for 15- 20 minutes. Call a Poison Control Center or doctor for further treatment advice.

Have the product container or label with you when calling a Poison Control Center or doctor or going for treatment.

Environmental Hazards
This product is toxic to fish. Do not apply directly to water. Do not contaminate water by disposal of wastes. Do not apply where spray may settle onto food or utensils.

Physical Or Chemical Hazards
Contents under pressure. Do not use or store near heat or open flame. Do not puncture or incinerate container. Exposure to temperatures above 130°F may cause bursting. Do not use this product in or on electrical equipment due to the possibility of shock hazard.

Storage and Disposal
Do not contaminate water, food or feed by storage or disposal.
STORAGE: Do not store near heat or open flame. Store in cool dry area away from children.
CONTAINER DISPOSAL:: Do not puncture or incinerate!
          If empty: Place in trash or offer for recycling if available.
          If partly filled: Call your local solid waste agency of 1-800-253-2687 for disposal instructions.